Written by
Nora Halvorsen Appliance Care EditorPublished October 26, 2026
VERIFIED
Error code35 / 75
ApplianceCooktop
What the display is saying
A reading of 35 or 75 means less supply voltage arrives at the induction housing assembly than it needs. The ESEC-UIB cooktop with ceramic glass, 30 inches, carries both numbers.
Technician procedure
This is the very procedure given for 30 and 70.
Measure the supply on the Filter Circuit Board, at the main incoming terminals pairs X1/X2 and X4/X5. The sheet expects 240 volts AC with a tolerance.
Inspect the two jumpers, one from X1 to X2 and one from X4 to X5.
X6 is the chassis ground wire.
With correct voltage present, the Filter Circuit Board is replaced.
Related codes
Code 30: the supply being too high rather than too low
Code 34: a communication fault in the left generator
Reach us in San Francisco or the wider Bay Area at (415) 449-0036 about Electrolux cooktop repair. Please have both codes, the model number and a short list of what you tried at hand.
Model compatibility: Electrolux reuses codes across series and model years, so 35 / 75 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
AC input voltage too low at the induction housing assembly.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux ECCI3068AS 30-inch induction cooktop repair for San Francisco and Bay Area homes: dead zones, pan detection and control errors tested before…
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
