Written by
Nora Halvorsen Appliance Care EditorPublished October 26, 2026
VERIFIED
Error code62
ApplianceCooktop
Reading 62
The sensor at the left rear inductor is reported too hot. Sheet 318200282 Rev B covers this for a ceramic glass induction cooktop of 30 inches with ESEC-UIB control, without naming a model or generation.
The checks, step by step
Ventilation: the airway and the fan must be correct.
Isolation: the white material must be complete and cover the entire inductor.
Connection: the sensor must be seated correctly on the induction housing assembly.
Resistance: if the sensor resistor is not close to 1000 ohms (blue wires) with the cooktop at room temperature, the inductor goes.
Board: the associated generator circuit board is replaced at the end.
Code 52: a left rear sensor break instead of an overheat
Booking cooktop repair in the Bay Area
Dial (415) 449-0036 to talk about Electrolux cooktop work in San Francisco and the Bay Area. We will ask for the code, the model number and any steps you took; Electrolux cooktop repair sets out the details.
Model compatibility: Electrolux reuses codes across series and model years, so 62 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Left rear inductor temperature sensor too hot.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux ECCI3068AS 30-inch induction cooktop repair for San Francisco and Bay Area homes: dead zones, pan detection and control errors tested before…
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
