Written by
Nora Halvorsen Appliance Care EditorPublished October 26, 2026
VERIFIED
Error code64
ApplianceCooktop
What the 64 on the display tells you
The right rear inductor is the one involved, and its temperature sensor is too hot. This is sheet 318200282 Rev B territory: a 30-inch induction cooktop, ceramic glass, ESEC-UIB control, with no model or generation given.
Order of the technician steps
Make sure the ventilation (airway and fan) is correct.
See that the white isolation material surrounds the whole inductor without gaps.
Check that the sensor is properly attached to the induction housing assembly.
Swap in a new inductor if the sensor resistor is off approximately 1000 ohms (blue wires) at room temperature.
Finish by replacing the associated generator circuit board.
Code 54: a right rear sensor break rather than an overheat
San Francisco Electrolux cooktop service
Right rear sensor trouble on a San Francisco cooktop? Phone (415) 449-0036 with the code, the model number and your earlier checks in hand. More on Electrolux cooktop repair.
Model compatibility: Electrolux reuses codes across series and model years, so 64 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Right rear inductor temperature sensor too hot.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux ECCI3068AS 30-inch induction cooktop repair for San Francisco and Bay Area homes: dead zones, pan detection and control errors tested before…
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
