Written by
Nora Halvorsen Appliance Care EditorPublished October 26, 2026
VERIFIED
Error codeE2
ApplianceCooktop
An E2 on an induction cooktop refers to a fault in the LED lighting. The wording comes from an Electrolux support article published for Australia, and it covers Electrolux induction cooktops in general.
Resetting the cooktop
Cut power to the cooktop for at least 30 seconds.
Switch power back on and wait 30 seconds.
Try the cooktop again.
A built-in cooktop keeps its cable in place; the household safety switch is what cuts the power. Should E2 stay on the display after the reset, the next step is to contact service.
If E2 survives the reset, reach our San Francisco line at (415) 449-0036; see Electrolux cooktop repair for what the work covers across the Bay Area. Keep the code, the model number and a note of the power reset ready.
Model compatibility: Electrolux reuses codes across series and model years, so E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
E2 indicates a fault in the LED lighting of an Electrolux induction cooktop.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux ECCI3068AS 30-inch induction cooktop repair for San Francisco and Bay Area homes: dead zones, pan detection and control errors tested before…
Code 21 is a LIN bus error, either no communication or a shorted bus, on the 30-inch ceramic glass induction cooktop. The manual is a service procedure.
Either 30 or 70 reports AC input voltage that is too high at the induction housing assembly. The procedure is shared with the low-voltage codes 35 and 75.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
